Home
Back to Installs
place holder
place holder
Installs Part-1
Installs Part-2
Installs Part-3
Ground Control Suspension
2.5 L Engine Rebuild
M Coupe Diff Cover
Custom Ergonomics
Sparco Stress Bar

Installs Part-2
Improvement via modification

Carbon Fiber Intake Plenum
This factory replica carbon airbox weighs a scant 1.5 lbs.
Modified Armrest
Easy mod to your armrest to gain more clearance for your elbows. Helpful if you run a lowered seat and/or a steering wheel spacer.
Custom Stainless 3" Exhaust
With Evo III header and Burns Y-Pipe.
Z3 Rear Shock Tower Reinforcement
A cheap and easy way to help keep your rear shock towers from cracking over time.
E34 M5 Guibo
When you build up a high performance 2.5L S14 putting out over 250HP you start thinking about a beafier Guibo to handle the torque. This E34 M5 Guibo fits the bill.
Magnecor Ignition Wires w/ Low-Crossfire Bracket
The stock E30 M3 ignition wires are prone to failure due to the way they are packed into a hard plastic loom. This install addresses that issue.
740iL & E28 Motor Mounts
These motor mounts are both lower and stiffer than the stock E30 M3 mounts. But installing them takes a little work...
Smaller and Lighter Interstate Battery
This smaller battery saves some weight from the rear corner of the car. This is very advantageous to dynamic handling.
4-Point Welded In Roll Bar
A welded in roll bar or cage is a nice addition to any E30 M3. This article highlights some important steps in a "weld-in" operation.




Home
Back to Installs
place holder
place holder
Installs Part-1
Installs Part-2
Installs Part-3
Ground Control Suspension
2.5 L Engine Rebuild
M Coupe Diff Cover
Custom Ergonomics
Sparco Stress Bar