These paper gaskets are readily adaptable to the S14 engine and will help prevent intake leaks between the rubber isolator and the cylinder head.

The E30 M3 can experience a high idle condition caused by the throttle cables getting stuck outside of their adjusting barrels on top of the plenum. But there are clips which can prevent this from happening.

The quick release allows you to safely exit the car in an emergency. And the hub acts as a spacer, improving ergonomics.

The E30 M3 brake master cylinder measures 23 mm in diameter. You can stiffen up your brake pedal by converting to a 25 mm master cylinder.

Is your power steering fluid overheating at the track? Check out Tad Laird's solution.

Jimmy Pettinato shows us his custom fabricated aero-components. They're not Evo III but they are very trick.

Jimmy Pettinato tackles another project on his E30 M3 race car. This time it's a fuel cell install.

Before I had my current Ground Control suspension I drove for a while with an H&R "coil-over" kit. It was a nice setup but ultimately did not meet my needs.